Steering column switch module, assembly
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Spiral spring
CAUTION:
Position of spiral spring must not be changed once removed.
- Removing and installing → Spiral spring, removing and installing
2 - Steering Angle Sensor G85
- Removing and installing → Steering Angle Sensor G85 , removing and installing
3 - Socket head bolt
4 - Cruise Control Switch E45
- Removing and installing → Cruise Control Switch E45 , removing and installing
5 - Socket head bolt
6 - Turn Signal Switch E2
- Removing and installing → Turn Signal Switch E2 , removing and installing
7 - Retaining clip
8 - Steering Column Electronic Systems Control Module J527
- Removing and installing → Steering Column Electronics Systems Control Module J527 , removing and installing
- Multi-pin connector assignments → Steering Column Electronics Systems Control Module J527 , front multi-pin connector assignments
9 - Clamping bolt - 3 Nm
10 - Windshield Wiper/Washer Switch E22
- Removing and installing → Windshield Wiper/Washer Switch E22 , removing and installing
11 - Socket head bolt