Steering Angle Sensor G85 , removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Should the Steering Angle Sensor G85 require replacement, follow applicable component "Replacement" as well as "zero - calibrate" procedure using VAS 5051/5051 in operating mode "Guided Fault Finding".

Removing

Remove spiral spring → Spiral spring, removing and installing .

Fig 1: Removing Steering Angle Sensor G85 From Steering Column Electronic Systems Control Module J527

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove Steering Angle Sensor G85 - 1 - from Steering Column Electronic Systems Control Module J527 in direction of - arrow -.

Installing

Install in reverse order of removal, noting the following:

Perform "zero - calibrate" procedure using VAS 505/5052 in operating mode "Guided Fault Finding".