Windshield Wiper/Washer Switch E22 , removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove steering column switch module → Steering column switch module, removing and installing .

CAUTION:

Ensure steering is in straight ahead and centered prior to removing spiral spring.
Position of spiral spring must not be changed once removed.

Fig 1: Releasing Clip Fasteners To Remove Spiral Spring From Steering Column Switch Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Carefully release clip fasteners - arrows - and remove spiral spring - 1 - from steering column switch module.

Fig 2: Removing Steering Angle Sensor G85 From Steering Column Electronic Systems Control Module J527

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove Steering Angle Sensor G85 - 1 - from Steering Column Electronic Systems Control Module J527 in direction of - arrow -.

Fig 3: Identifying Screws And Windshield Wiper/Washer Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - 1 - and - 2 -.
Remove Windshield Wiper/Washer Switch E22 - 3 - from steering column switch module - arrow -.

Installing

Further Install in reverse order of removal, noting the following:

Ensure all fasteners and electrical connectors are properly connected and locked into place.
Install steering column switch module Installing .

Tightening torque

Component	Nm
Windshield Wiper/Washer Switch E22 to Steering Column Electronics Systems Control Module J527	0.6