Front final drive, assembly overview
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Audi A4, 2008 Audi S4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Oil seal
- Between final drive and transmission housing
- Replacing → Final drive/transmission housing oil seal, replacing
2 - Shim
- Behind tapered roller bearing outer race
3 - Outer race for tapered roller bearing
4 - O-ring
- Replace
5 - Plug, 35 Nm
- Replace
6 - Flange shaft (right-side)
- Removing and installing → Flanged shaft (right side), removing and installing
7 - Retaining ring
- Replace
8 - Flange shaft oil seal (right-side)
- Replacing → Flanged shaft oil seal (right side), replacing
9 - Bolt, 23 Nm
- Follow correct tightening sequence → Final drive cover O-ring, replacing
10 - Cover for final drive
11 - Shim
- Behind tapered roller bearing outer race
12 - Outer race for tapered roller bearing
13 - O-ring for final drive cover
- Replacing → Final drive cover O-ring, replacing
14 - Differential
15 - Spring pin
16 - Selector shaft lever
17 - Oil seal for selector shaft
- Replacing → Selector shaft oil seal, replacing
18 - Bolt, 23 Nm
19 - Flange shaft (left-side)
- Removing and installing → Flange shaft (left-side), removing and installing