Flanged shaft oil seal (right side), replacing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Audi A4, 2008 Audi S4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Special Tools - Flanged Shaft Oil Seal (Right Side), Replacing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Special tools, testers and auxiliary items required

Drip tray V.A.G 1306
Extractor lever VW 681
Thrust piece T10138

Procedure

Transmission installed

NOTE:

General repair instructions → General repair instructions .
Read the rules for cleanliness when working on the automatic transmission → Rules for cleanliness .

Place drip tray V.A.G 1306 under transmission.
Remove flange shaft (right-side) → Flanged shaft (right side), removing and installing .

Fig 2: Removing Flange Shaft Oil Seal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull out flange shaft oil seal.

Fig 3: Driving New Seal In Onto Stop

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Lubricate outer circumference of seal with gear oil
Drive new seal in onto stop (take care to keep seal straight).

Installation position: open side of seal faces transmission.

Pack space between sealing lip and dust lip half full with sealing grease G 052 128 A1 .
Install flange shaft (right-side) → Flanged shaft (right side), removing and installing .
Check oil level in front final drive → Front final drive gear oil .