Selector shaft oil seal, replacing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Audi A4, 2008 Audi S4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Pry Lever 80-200

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removal lever 80-200

Fig 2: Thrust Piece T10135

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Thrust piece T10135

Procedure

NOTE:

General repair instructions → General repair instructions .
Read the rules for cleanliness when working on the automatic transmission → Rules for cleanliness .

Shift selector lever to position "P".
Remove transmission support (left-side) → Transmission support and transmission mounting, removing and installing (left and right) .

Fig 3: Using Pry Lever - RMV Outside Mirror 80-200 To Pry Ball Socket On Selector Lever Cable Off Selector Shaft Lever

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Use removal lever 80-200 to pry ball socket - 1 - on selector lever cable off selector shaft lever.

NOTE:

Do not bend or kink the selector lever cable.
- Item 2 - can be disregarded.

Fig 4: Driving Out Spring Dowel Sleeve At Lever/Shift Rod Of Travel Toward Front

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive out roll pin - 1 - at selector shaft lever - 2 - - arrow - until it is possible to detach selector shaft lever from selector shaft.

Fig 5: Prying Seal Out With A Screwdriver

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push a small screwdriver through seal and pull it out.
Lubricate outer circumference and the space between sealing lips of seal with ATF.
Install new seal onto selector shaft.

Installation position: open side of seal faces transmission.

Fig 6: Pressing On New Oil Seal Using Thrust Piece T10135 And Assembly Lever As Far As Stop

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press on new oil seal using thrust piece T10135 and assembly lever - A - as far as stop; make sure that oil seal remains straight.

NOTE:

To prevent slippage when pressing in oil seal, place something as a base (e.g. piece of rubber) between assembly lever and subframe - arrow -.

Before installing, drive roll pin in selector shaft lever back through lever in opposite direction.
Push selector shaft lever onto selector shaft and drive in roll pin.

Fig 7: Pressing Selector Lever Cable Onto Ball Head Of Selector Shaft Lever

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press selector lever cable - 1 - onto selector shaft lever - 3 -.

NOTE:

Do not bend the selector shaft lever when pressing on the ball socket, as otherwise it will no longer be possible to precisely adjust the gear selector mechanism
- Item 2 - can be disregarded.

Check ATF level → ATF level, checking and correcting .