Oil Pan, MECHATRONIC And Transmission Fluid Pump Overview

WARNING: This page is about a different variant/trim than selected.

NOTE:

Ignore items -8 through 14- here, for a description, refer to TRANSMISSION FLUID COOLER AND FILTER OVERVIEW .

Ignore items -19 through 23- here, for a description, refer to TRANSMISSION OIL OVERVIEW .

Fig 1: Oil Pan, Mechatronic And Transmission Fluid Pump Overview

Courtesy of AUDI OF AMERICA, LLC

1 - Fluid Pan
- Removing and installing, refer to OIL PAN
2 - Bolt
- Tightening specification and sequence, refer to Fig 2
- Quantity: 5
- Replace
3 - Gasket
- Replace
4 -Bolt
- Tightening specification and sequence, refer to Fig 3
- Quantity: 10
- Replace
5 - Direct Shift Gearbox (DSG) Transmission Mechatronic -J743-
- With O-rings on connector
- Replace O-rings
- Removing and installing, refer to Direct Shift Gearbox (DSG) Transmission Mechatronic -J743-
6 - Ventilation Pipe
- Pressed into transmission
- Replace after removal
7 - Bleed Cap
- Placed on bled pipe
15 - Transmission Oil Pump
- Removing and installing, refer to TRANSMISSION OIL PUMP
- Insert with new seal
16 - Bolt
- Tightening specification and sequence, refer to Fig 4
- Replace
- Quantity: 4
- Different bolts depending on version
17 - Transmission Oil Pump Cover
- With seal
- Replace
- Removing and Installing, refer to TRANSMISSION OIL PUMP
18 - Bolt
- Tightening specification and sequence, refer to Fig 5
- Replace
- Quantity: 4
24 - Guard Plate
- Depends on version
25 - Bolt
- 32 Nm
- Quantity: 4

Fig 2: Identifying Oil Pan And Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -arrows- diagonally in steps to 16 Nm.

Fig 3: Identifying Direct Shift Gearbox Bolt Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts in 2 steps in the following sequence: -1 through 10- :

-- Tighten bolts to 5 Nm.-- Tighten bolts an additional 90°.

Fig 4: Transmission Oil Pump Tightening Specification And Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten bolts -arrows- in a diagonal sequence (different bolts depending on version):

Countersunk Bolts -A- :

-- Tighten countersunk bolts to 8 Nm.

Flat Head Bolts -B- :

-- Tighten flat head bolts in 2 stages as follows:

-- Tighten bolts to 8 Nm.-- Tighten bolts an additional 90°.

Fig 5: Identifying Cap For Transmission Oil Pump And Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -arrows- diagonally in steps to 8 Nm.

Fig 6: Transmission Sensors And Bolts

Courtesy of AUDI OF AMERICA, LLC

A -	Transmission input speed sensor and clutch oil temperature sensor.
	Removing and Installing, refer to Transmission Input Speed Sensor -G182- AND Clutch Oil Temperature Sensor -G509- .
B -	Bolt
	10 Nm
C -	Electrical connection