Transmission Input Speed Sensor -G182- And Clutch Oil Temperature Sensor -G509-

WARNING: This page is about a different variant/trim than selected.

Removing

CAUTION:

Risk of transmission damage.

Do not run engine or tow vehicle with oil pan removed or without transmission fluid.

NOTE:

General repair instructions, refer to REPAIR INFORMATION .

Observe cleanliness rules when working on transmissions, refer to CLEAN WORKING CONDITIONS .

-- Remove the ATF pan. Refer to OIL PAN .

-- Remove the Direct Shift Gearbox (DSG) transmission Mechatronic -J743-. Refer to Direct Shift Gearbox (DSG) Transmission Mechatronic -J743- .

-- Remove bolt -B-.

Fig 1: Transmission Sensors And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove transmission input speed sensor and clutch oil temperature sensor item -A- together with the wire -C- from transmission.

Installing

Install in reverse order, paying attention to the following:

Tightening specifications, refer to:

-- Coat transmission input speed sensor and clutch oil temperature sensor with gear oil.

-- Insert transmission input speed sensor and clutch oil temperature sensor in side opening on transmission and tighten. Refer to Figure.

-- Install the oil pan. Refer to OIL PAN .

-- Perform a basic setting using the vehicle diagnostic tester.