Dual Mass Flywheel Overview
NOTE:
- For assembly work, secure the engine on the engine and transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
- Servicing clutch, refer to Removal and Installation or to Removal and Installation .
- Bolt
- Replace
- 60 Nm plus an additional 90° turn
- Dual Mass Flywheel
- Different versions.
- Removing and installing, refer to DUAL MASS FLYWHEEL
- Only possible to install in one position
- Diamond Disc
- Replace the dual mass flywheel bolts each time that they are loosened
- Only possible to install in one position
- Sensor Wheel
- For the Engine Speed (RPM) sensor -G28-
- Only possible to install in one position
- Fitting Pin
- Crankshaft Shaft Seal, Transmission Side
- Removing and installing, refer to CRANKSHAFT SEAL, TRANSMISSION SIDE
- Diamond Disc
- Replace the dual mass flywheel bolts each time that they are loosened
- Only possible to install in one position