Dual Mass Flywheel

Special tools and workshop equipment required

Removing

Fig 1: Identifying Dual-Mass Flywheel & Bolts

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of destroying dual mass flywheel.

Remove bolts -B- by hand, not with an air-powered or impact wrench.
When removing bolts, ensure bolt head does not come in contact with dual mass flywheel.
Rotate dual mass flywheel -A- so bolts -B- are centered to holes -arrows-.

-- Place the 3067 into the hole on the cylinder block -B-, then remove the dual mass flywheel bolts.

Fig 2: Identifying Retainer -3067- Inserted In Hole On Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

Installing

Install in reverse order, paying attention to the following:

CAUTION:

Risk of chafing.

Replace the diamond discs, refer to 3 and 7 after each time that the dual mass flywheel bolts are loosened.

NOTE:

Replace bolts that are tightened to the specification.
The dual mass flywheel with sensor wheel and diamond discs is only able to be installed in one position.

-- Place the 3067 into the hole on the cylinder block -A-.