Left Flange Shaft

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Secure the transmission to the engine and transmission holder VAS 6095. Refer to TRANSMISSION, SECURING IN ENGINE/TRANSMISSION HOLDER .

-- Tilt the transmission back on the engine/transmission holder so the transmission fluid does not drain out.

-- Remove the bolts -arrows- from the flange shaft mounting bracket.

Fig 1: Locating Flange Shaft Mounting Bracket Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left flange shaft -2- from the transmission -arrow A-.

Fig 2: Identifying Left Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -1- and -arrow 3, B-.

-- Remove the torque converter. Refer to TORQUE CONVERTER .

Installing

Install in reverse order, paying attention to the following:

Tightening specification, refer to FRONT FINAL DRIVE OVERVIEW .

-- Always clean the left flange shaft and the torque converter bell housing in the area where the differential is accessed -arrow A- and the shaft seal -arrow B-.

Fig 3: Replacing Shaft Seal Between Differential And Transmission Housing

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Replace the shaft seal between the differential and transmission housing -arrow B- if it is damaged. Refer to FRONT FINAL DRIVE OVERVIEW .

-- Fill the space between the sealing- and dust lip half way with sealing grease G 052 128 A1.

-- Install the torque converter. Refer to TORQUE CONVERTER .

-- Rotate the torque converter -1- until the opening to the differential -arrow 3- is visible.

Fig 4: Identifying Left Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Install the left flange shaft -2- into the transmission -arrow B-. When doing this, insert the flange shaft centrally into the shaft seal on the front differential -arrow 3-.

NOTE:

If the flange shaft is not centered, the flange shaft splines -2- will damage the shaft seal between the final drive and the transmission housing.

The shaft seal must be replaced if it is damaged.

Ignore -arrow A-.

-- Tighten the left flange shaft mounting bracket -arrows-.

Fig 5: Locating Flange Shaft Mounting Bracket Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Refer to GEAR OIL LEVEL IN FRONT FINAL DRIVE, CHECKING AND FILLING after installing the transmission.