Gear Oil Level In Front Final Drive, Checking And Filling

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Oil Collecting and Extracting Device V.A.G 1782
Protective eyewear

Procedure

Gear oil temperature at approximately 20 °C (68 °F) (room temperature).
Move the vehicle onto a 4-column shop hoist or over a work pit so it is completely level.
Tightening specification, refer to FRONT FINAL DRIVE OVERVIEW .

NOTE:

General repair instructions, refer to REPAIR INFORMATION .

Automatic transmission clean working conditions, refer to CLEAN WORKING CONDITIONS .

Always maintain the specified transmission fluid level; the transmission is very sensitive to overfilling.

Follow all applicable disposal regulations.

-- Place the V.A.G 1782 under the transmission.

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove the plug -arrow-.

Fig 1: Gear Oil Level In Front Final Drive, Checking And Filling

Courtesy of AUDI OF AMERICA, LLC

Specified value: The oil level is correct when the front final drive is filled to the lower edge of the filler opening.

-- Allow the excess gear oil to drain if necessary.

-- Add gear oil if necessary until it runs out of the gear oil filler hole.

For the correct transmission fluid.

NOTE:

Replace the drain plug and gasket.

-- Tighten the new sealing plug.