OVERVIEW - SELECTOR LEVER, Multifunction Transmission Range Switch -F125-
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 12 Nm
- Cover
- Nut
- 7 Nm
- Lock Washer
- Replace if damaged.
- Bolt
- 6 Nm
- Multifunction Transmission Range Switch -F125-
- Removing and installing. Refer to Multifunction Transmission Range Switch -F125-, REMOVING AND INSTALLING .
- Adjusting. Refer to Multifunction Transmission Range Switch -F125-, ADJUSTING .
- Right Selector Shaft Seal
- Removing and installing. Refer to RIGHT SELECTOR SHAFT SEAL, REMOVING AND INSTALLING
- Selector Shaft
- Left Selector Shaft Seal
- Removing and installing. Refer to LEFT SELECTOR SHAFT SEAL, REMOVING AND INSTALLING .
- Selector Lever
- Removing and installing. Refer to SELECTOR LEVER, REMOVING AND INSTALLING .
- Washer
- Nut
- 12 Nm
The Multifunction Transmission Range Switch -F125- is connected to the wiring harness once with the connector -3- and once directly to the Multifunction Transmission Range Switch -F125-.
-- Always check both connectors for water entry, contact corrosion and damage before replacing the Multifunction Transmission Range Switch -F125-.