Auxiliary Components Bracket, Removing And Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Removal

Proceed as follows:

-- Remove the ribbed belt, refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the generator, refer to GENERATOR, REMOVING AND INSTALLING .

-- Remove the A/C Compressor, refer to COMPRESSOR, REMOVING AND INSTALLING ON BRACKET .

-- Remove screws -1 to 5- and remove accessory assembly bracket.

Fig 1: Accessory Bracket Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

Installation

Tightening specification, refer to RIBBED BELT DRIVE OVERVIEW .

Install in reverse order of removal. Note the following:

-- Tighten accessory assembly bracket bolts, refer to Figure.

-- Install the A/C Compressor, refer to COMPRESSOR, REMOVING AND INSTALLING ON BRACKET .

-- Install power steering pump, refer to POWER STEERING PUMP, REMOVING AND INSTALLING .

-- Install the generator, refer to GENERATOR, REMOVING AND INSTALLING .

-- Install ribbed belt tensioner, refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .

-- Install the ribbed belt, refer to RIBBED BELT, REMOVING AND INSTALLING .