Upper Oil Pan Overview
- Spring
- Support
- Oil Pump Input Shaft
- Oil Pan (upper section)
- Removing and installing, refer to UPPER OIL PAN
- Bracket
- For the electrical wiring harness
- Bolt
- 9 Nm
- Oil Pressure Regulation Valve -N428-
- Removing and installing, refer to OIL PRESSURE REGULATION VALVE
- Bolt
- 9 Nm
- Sealing Piece
- Replace
- 2 pieces
- Bolt
- Tightening specification and sequence, refer to Fig 3
- Crankshaft Shaft Seal, Belt Pulley Side
- Removing and installing, refer to CRANKSHAFT SHAFT SEAL, BELT PULLEY SIDE, REPLACING .
- Right Idler Roller for Ribbed Belt
- Pay attention to the installed position
- Idler Roller Cover
- Bolt
- Tightening specifications, refer to "Bolt" in numbered list under RIBBED BELT DRIVE OVERVIEW
- Sealing Flange (belt pulley side)
- Removing and installing, refer to SEALING FLANGE, BELT PULLEY SIDE
- O-ring
- Replace
- Oil Pressure Switch -F22-
- 20 Nm
- Switching pressure 2.5 to 3.2 bar
- 2-pin, gray insulation
- Removing and installing, refer to Oil Pressure Switch -F22-
- Seal
- Replace
- Bolt
- 9 Nm
- Oil Dipstick
- O-ring
- Replace
- Guide Tube for oil Dipstick
- Bolt
- 9 Nm
- O-ring
- Replace
- O-rings
- Replace
- Gasket
- Replace
- Bolt
- 9 Nm
- Oil Return Pipe
- O-ring
- Replace
- Gasket
- Replace
- Alignment Bushing
- 2 pieces
- Bolt
- Tightening specification and sequence, refer to Fig 2
- Bolt
- Tightening specifications ENGINE, INSTALLING => Engine to Automatic Transmission 09D
- Locking Bolt for the "TDC" Marking.
- 35 Nm
- Use a long hex socket wrench with a ball head for removing and tightening
- Seal
- Replace
-- Tighten bolts in 2 stages as follows:
| Step | Bolt | Tightening Specification |
|---|---|---|
| 1. | -1 through 4- | 5 Nm in a diagonal sequence |
| 2. | -1 through 4- | 15 Nm in a diagonal sequence |