Instrument cluster, values to be entered when replacing

The following must be observed when replacing the instrument cluster:

NOTE:

Always code the instrument cluster.
Write down values displayed on the VAG 1551 Scan Tool (ST) of all adaptation channels of the service reminder functions and trip odometer before replacing the instrument cluster.
These values must be entered because counting goes back to the next required service.
Make note of the trip odometer reading before replacing the instrument cluster and enter this value into the new instrument cluster according to instructions.
Also in countries with odometers in miles, the adaptation of the odometer must be made in km (miles x 1.609 = kilometers). It is necessary to convert miles into km or the values previously noted must be entered.
After the instrument cluster has been replaced, do the following.

Code instrument cluster. See CODE CONTROL MODULE, (SCAN TOOL FUNCTION 07) .
Enter remaining values for the next oil change service. See ADAPTATION OF SERVICE INDICATOR FOR OIL CHANGE SERVICE (DISTANCE) .
Enter noted values for the next Service Inspection 1 (distance). See ADAPTATION OF SERVICE INDICATOR FOR INSPECTION SERVICE I (DISTANCE) .
Enter noted values for the next Service Inspection 1 (time). See ADAPTATION OF SERVICE INDICATOR FOR INSPECTION SERVICE I (TIME) .
Enter noted values for the next Service Inspection 2 (time). See ADAPTATION OF SERVICE INDICATOR FOR INSPECTION SERVICE II (TIME) .
Enter odometer reading (kilometers/miles). See ADAPTATION OF KILOMETER-/MILE DISPLAY .