LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TSX Special Edition, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 88 (Manual Transmission (4-CYL)) >> Reverse Lockout Solenoid Disassembly/Reassembly

Reverse Lockout Solenoid Disassembly/Reassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake air duct (see step 2 on REMOVAL ).
  2. Remove the air cleaner housing (see AIR CLEANER REMOVAL/INSTALLATION ).
  3. Carefully remove the shift cables and the cable bracket together to avoid bending the shift cables (see step 11 on TRANSMISSION INSTALLATION ).
  4. Disconnect the reverse lockout solenoid 2P connector (A).
    Fig 1: Identifying Reverse Lockout Solenoid 2P Connector (A) And Reverse Lockout Solenoid (B)
    G07768132Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the reverse lockout solenoid (B).
  6. Remove the pin (A), the select lock return spring (C), and select lock cam B.
    Fig 2: Identifying Pin (A), Select Lock Cam B And Select Lock Return Spring (C)
    G07768133Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Install the components of the reverse lockout solenoid in the reverse order of removal.
  8. Clean any dirt and oil from the sealing surface.
  9. Apply liquid gasket, P/N 08718-0003 evenly to the shift arm cover mating surface of the reverse lockout solenoid. Install the component within 5 minutes of applying the liquid gasket.
    NOTE: If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
    Fig 3: Identifying Liquid Gasket
    G07768134Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Install the reverse lockout solenoid (A).
    Fig 4: Reverse Lockout Solenoid (A) And Reverse Lockout Solenoid 2P Connector (B) With Torque Specifications
    G07768135Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Connect the reverse lockout solenoid 2P connector (B).
  12. Carefully install the shift cables and the cable bracket together to avoid bending the shift cables (see step 55 on TRANSMISSION DISASSEMBLY ).
  13. Install the air cleaner housing (see AIR CLEANER REMOVAL/INSTALLATION ).
  14. Install the intake air duct (see step 9 on EXHAUST PIPE AND MUFFLER REPLACEMENT ).
scientia non olet · About LEMON Manuals