Installation, continued

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Gear-Shift Position Sensor Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

The bracket for the dip stick pipe. Ensure that the O-ring is in position. Tighten the nut
Torque: 25 Nm
The lever on the gear shift linkage rod.
Torque: 16 Nm

If the bracket for the transmission cable has not been removed:

Install the transmission cable on the lever. Use a washer and locking clip. Apply a small amount of grease (P/N 1161241- 3) to the lever shaft journal.

If the transmission cable bracket was removed:

Install the bracket. Adjust the transmission cable according to Adjusting the transmission cable .