Checking resistance

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Transmission connector D disconnected.

  Check the circuit for solenoid SLT. Measure the resistance between terminals #D3 and #D4 on transmission connector D. The resistance must be 5-5.6 Ω at 20°C.

  Other information: 

  • To disconnect the transmission connectors, see Connectors transmission, disconnecting / connecting
  • For information about signals, see Signal description. Transmission control module (TCM) .
  Fig 3: Identifying 8-Pin Transmission Connector Terminals

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 4: Identifying Ohms Display

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was the resistance OK? 

• OK 

  Refer to Checking the wiring 

• NOT OK 

  Refer to Checking the wiring and component