Checking the wiring
- Ignition off
- Disconnect transmission connector D.
Check the cable between transmission control module (TCM) terminal #A52 (#A52) and transmission connector terminal #D3 (control module side). Check for an open-circuit. See Open-circuit, permanent faults .
Check the cable between control module terminal #B10 (#A70) and transmission connector terminal #D4 (control module side). Check for an open-circuit. See Open-circuit, permanent faults .
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- To disconnect the transmission connectors, see Connectors transmission, disconnecting / connecting
- For information about signals, see Signal description. Transmission control module (TCM) .
Was a fault found in the wiring?
- YES
Refer to Verification
- NO
Refer to Checking the control module