Checking the connector

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off
Check the connectors for the ABS control module, the yaw rate sensor, the lateral acceleration sensor and the brake pressure sensor. Check for contact resistance and oxidation
Reinstall the components, reconnect the connectors etc.
Ignition on.
Test drive the car. See Test driving .

Read off the status of the diagnostic trouble code (DTC).

Other information:
- To connect the breakout box, see Connecting the ABS/DSTC breakout box
- To disconnect the connector for yaw rate sensor 1, see Replacing the yaw rate sensor (1) and the lateral acceleration sensor in the center console (DSTC) . To disconnect the connector for yaw rate sensor 2, see Replacing the yaw rate sensor (2) (DSTC)
- To disconnect the connectors for the brake pressure sensors, see Pressure sensor, master cylinder, replacing
- See Checking wiring and terminals
Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the status of the diagnostic trouble code (DTC) intermittent?