Drive Shaft Right, Replacing: Installation

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For tightening torques, see Tightening Torque .

Lubricate the drive shaft sealing surface.

Use oil. See Lubrication Transmission .

Fig 1: Leaving Lower Screw In Place

GLL150213

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use new screws and nuts.

Adjust the position of the wheel spindle/spring strut. See Wheel Knuckle/Spring Strut, Calibrating .

Fig 2: Identifying Brake Grommets

GLL150212

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Brake Grommet

GLL150211

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten, see Summary Of Tightening Torques For Specific Components .

Fig 4: Removing Drive Shaft Screw Using A Screwdriver As A Counter Hold On Brake Disc

GLL105489

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten, see Summary Of Tightening Torques For Specific Components .

Fig 5: Locating Driveshaft Cap And Bolts

GLL150210

Courtesy of VOLVO CARS OF NORTH AMERICA.

M8