Installing and tightening the front suspension components
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Install the nut for the ball joint pinion. Counterhold the ball joint pinion while tightening so that the ball joint boot cannot turn. Use a new M12 nut.
Tighten according to Summary of tightening torques for specific components
Tighten the drive shaft screw. Use a new screw.
Counterhold the brake disc. Use a screwdriver. Tighten. See Summary of tightening torques for specific components
Use angle gauge 9512050 .
Install:
- the link for the anti-roll bar. Counterhold the ball joint pinion while tightening so that the ball joint boot cannot turn. Use a new lock nut. Tighten. See Summary of tightening torques for specific components
- The ABS line in the mounting in the spring strut
- the wing liner with support plate and nuts.