Installing the torque converter screws

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Torque Converter Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Use new screws, Torx TX 50

Align the torque converter against the carrier plate. Do this by turning the engine with the nut for the crankshaft pulley and turning the torque converter.

Install all 6 x screws loosely. Insert the screws as far as the screw heads sit almost against the carrier plate. Tighten. See Summary Of Tightening Torques For Specific Components .

NOTE: Remove the socket wrench from the crankshaft.