Installing and tightening the front suspension components
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Fit the nut to the ball joint pin. Counterhold the ball joint pin while tightening so that the gaiter does not turn. Use a new nut, M12.
Tighten, see Summary of tightening torques for specific components .
For steel control arm, see:
Tighten the drive shaft screw. Use a new screw. Counterhold with a screwdriver in the brake disc. Tighten as described in Summary of tightening torques for specific components . Use: 9512050 .
Fit on the left-hand side:
- the link to the anti-roll bar. Counterhold the ball joint pin while tightening so that the gaiter does not turn. Use a new lock nut. Tighten in accordance with Summary of tightening torques for specific components .
- the tie rod. Tighten in accordance with Summary of tightening torques for specific components .
Install:
- the ABS line to the bracket in the spring strut
- the wing liner with support plate and nuts.