Fitting the torque converter screws.

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Torque Converter Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Use new screws, Torx TX50.

Align the torque converter to the carrier plate, by means of pulling round the engine with the nut to the crankshaft pulley and turning the torque converter.

Fit all screws, 6, loosely. Insert the screws as far as the screw heads sit against the carrier plate. Tighten in accordance with: Summary of tightening torques for specific components .

NOTE: Remove the socket wrench from the crankshaft.