Installing the screw for the ground lead and cable conduit

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cable Conduit And Ground Lead Bracket On Sub-Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the screw for the ground lead bracket in the sub-frame. Tighten to 10 Nm
the screw and the ground lead on the transmission. Tighten to 25 Nm
the parking heater and the screws. Tighten to 25 Nm
the fuel line in the clips on the sub-frame
the screw in the cable conduit
the front splash guard
the splash guard under the engine
the nuts for the left fender liner and damping protection.

Rivet the fender liner into place.

Install the wheels. See Installing Wheels .