Installing Wheels

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Special tools:

9512835

Fig 1: Installing Wheel Studs In Sequence

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ensure that the brake disc and wheel rim mating surfaces are clean. Grease the hub center location dowel for the rim. Use installation paste 1161397-3 .

Install the wheel studs lightly. Then tighten crosswise. Tighten to 140 Nm . Use torque socket 9512835 if an impact wrench is being used.

Crosswise tightening and torque tightening is important to prevent stresses in the brake disc.

NOTE: The torque socket is designed for use with a standard, pneumatic impact nut runner providing a torque of 250-350 Nm .