Greasing the Gaiter

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Applying Grease In Boot

Courtesy of VOLVO CARS OF NORTH AMERICA.

Grease the gaiter.

Apply the remaining grease from Lubricating the Constant Velocity Joint .

NOTE: Make sure that there is no grease on the mating surfaces between the gaiter against he universal joint and the shaft.

Remove excess grease. Use methylated spirit.

Ensure that the gaiter is in position on the drive shaft universal joint.

Install a new clamp. Use pliers .