LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Rear Axle, Drive Shafts - Removal, Replacement And Installation) >> Drive Shaft, CV Joint (Ambulance; 2003-2004) >> Boot, half shaft, replacing >> Disassembly >> Replacing the inner boot: Remove the clamps from the inner boot

Replacing the inner boot: Remove the clamps from the inner boot

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Cut the boot and remove it from the shaft.

NOTE: The inner  constant velocity joint can be cleaned while assembled  and blown clean. For greasing, see Lubricate the constant velocity joint thoroughly . Install the boot on the shaft. Carry out Apply grease in the boot , Vent the boot .
scientia non olet · About LEMON Manuals