Brush the drive shaft thoroughly with soapy water
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Position the drive shaft on a support in a workshop press. Carefully press out the vibration damper from the drive shaft.
Clean the assembled constant velocity joint and blow clean. Grease the joint. See Lubricate the constant velocity joint thoroughly
Install the boot on the shaft. Carry out operations Apply grease in the boot and Vent the boot