Installing the flange on the pinion

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Pinion Flange, Tool 999 7058 And 999 5652

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the flange as marked, see Removing the nuts for the bevel gear flange .

If necessary, use press tool 9995504 .

Installing a new nut in the carrier

Install a new lubricated nut .

NOTE:

There must be no axial play.

Tighten to 180-200 Nm . Use counterhold 9995652 with adapter 9997058 .

NOTE:

Do not exceed 200 Nm. The forces on the pinion's bearing may become too great, causing bearing failure.