For Cleaning / Assembly And Greasing The Outer Joint, See Below

The Joint Can Be Cleaned When Assembled And Blown Clean Before Greasing. See Lubricate The Constant Velocity Joint Thoroughly . For Disassembly And Inspection, See Mark The Outer Constant Velocity Joint Outer Ring, Ball Holder And Inner Ring , Remove The Ball Bearings , Remove The Ball Bearing Holder And The Inner Ring From The Shaft , Wash The Constant Velocity Joint Components Thoroughly  And Install The Inner Ring In The Ball Holder . For Greasing See Lubricate The Constant Velocity Joint Thoroughly . To Install The Boot And Joint, See Replace The Snap Ring , Install The New Boot / Boots On The Drive Shaft , Apply Grease In The Boot  And Vent The Boot .