LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Axle, Drive Shafts - Removal, Replacement And Installation >> Drive Shaft, CV Joint (B5204T5, Aw55-50/51SN; 2004-2007) >> Boot, Half Shaft, Replacing >> Reassembly >> Apply Grease In The Boot

Apply Grease In The Boot

Fig 1: Securing Boot With 9512619
GLL109791Courtesy of VOLVO CARS OF NORTH AMERICA.

Apply The Remaining Grease From Lubricate The Constant Velocity Joint Thoroughly .

NOTE:

Ensure That There Is No Grease On The Mating Surfaces Between The Boot And The Constant Velocity Joint And The Shaft.

Remove Excess Grease. Use Methylated Spirit.

Ensure That The Boot Is In Position On The Constant Velocity Joint Housing.

Install A New Clamp. Use Pliers 9512619 .

scientia non olet · About LEMON Manuals