All Wheel Drive Clutch, Removing And Installing: Installing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install in reverse order of removal while noting the following:

-- Remove the old O-ring -arrow- from the all wheel drive clutch.

-- Insert the new O-ring -arrow- and lightly lubricate with High Performance All Wheel Drive Clutch Oil.

-- Insert the all wheel drive clutch -1- in the rear final drive. Install :T10093  for exact guidance.

Fig 1: Haldex Clutch In Rear Final Drive

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Rotate at flange/driveshaft -2- and insert the all wheel drive clutch all the way.

-- Tighten the bolts -arrows-. Refer to OVERVIEW - ALL WHEEL DRIVE CLUTCH 

Fig 2: Identifying Haldex Clutch To Rear Final Drive Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the connector -B- from the All Wheel Drive Control Module -J492- -A-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The connector -C- must also be connected.

-- Attach the driveshaft to the rear final drive. Refer to DRIVESHAFT, REMOVING AND INSTALLING .

-- Install the pendulum support with new bolts -1- on the transmission. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING - 2.0L , PENDULUM SUPPORT, REMOVING AND INSTALLING - 3.6L .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the center tunnel heat shield under the intermediate bearing if removed. Refer to COMPONENT LOCATION OVERVIEW - HEAT SHIELD .

-- Install the exhaust system and align it without tension. Refer to OVERVIEW - MUFFLER - 2.0L , OVERVIEW - MUFFLER - 3.6L .

-- Add High Performance All Wheel Drive Clutch Oil and check the oil level in the all wheel drive clutch. Refer to ALL WHEEL DRIVE CLUTCH OIL, DRAINING AND FILLING .