Overview - Crankshaft
WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Block
- Cylinder Block Bearing Shell
- Replace after removing
- Upper bearing shell
- With oil groove
- Quantity: 5
- Refer to Main Bearing Shells Allocation .
- Crankshaft
- Refer to Crankshaft, Removing and Installing .
- Refer to Crankshaft, Measuring Axial Clearance .
- Refer to Crankshaft, Measuring Radial Clearance .
- Refer to Check and Adjustment Values .
- Refer to Main Bearing Shells Allocation .
- Crankshaft Bearing Cap Bearing Shell
- Replace after removing
- Without oil groove
- Quantity: 5
- Refer to Main Bearing Shells Allocation .
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Quantity: 10
- Crankshaft Bearing Cap
- Quantity: 5
- Bolt
- 10 Nm +90°
- Replace after removing
- Quantity: 3
- Sensor Wheel
- Replace after removing
- For the Engine Speed Sensor -G28-
- Refer to Sensor Wheel, Removing and Installing .
- Thrust Washer
- For bearing 3
- Quantity: 2
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Quantity: 6
Crankshaft - Tightening Specification and Sequence
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -arrows- and -1- through -10- | Install all the way by hand |
| 2. | -1 through 10- | 65 Nm |
| 3. | -1 through 10- | 90° |
| 4. | -arrows- | 15 Nm |
| 5. | -arrows- | 90° |