Overview - Rear Lid
- Rear Lid
- Refer to Rear Lid, Removing and Installing .
- Refer to Rear Lid, Adjusting .
- Rear Lid Lock Unit -VX25-
- Nut
- 20 Nm
- Quantity: 2
- Bolt
- 2 Nm
- Quantity: 4
- Rear Lid Handle Adapter Piece
- Rear Lid Handle
- With Release Button in Rear Lid Handle -E234-
- With Rearview Camera - R189- depending on the equipment/version
- With Rear Peripheral Camera - R246- depending on the equipment/version
- Refer to Rear Lid Handle, Removing and Installing .
- Clip
- Quantity: 4
- Expanding Nut
- Quantity: 4
- Bolt
- 8 Nm
- Quantity: 2
- Adjusting Buffer Stop
- Lower Adjusting Buffer
- Refer to Lower Adjusting Buffer, Removing and Installing .
- Refer to Lower Adjusting Buffer, Adjusting .
- Hinge
- Refer to Hinge, Removing and Installing .
- Bolt
- 10 Nm
- Replace after removing
- Quantity: 4
- Seal for Hinge
- Nut
- 8 Nm
- Quantity: 2
- Nut
- Replace after removing
- Quantity: 2
- Refer to Fig 2
- Ball Pin
- 20 Nm + 90°
- Replace after removing
- Quantity: 2
- Refer to Ball Pin, Removing and Installing .
- Gas-Filled Strut
- Left and right
- Depending on equipment/version
- Refer to Gas-Filled Strut, Removing and Installing .
- Refer to Gas-Filled Strut, Preparing for Disposal .
- Mounting Bracket
- Depending on equipment/version
- Bolt
- 20 Nm + 90°
- Replace after removing
- Quantity: 4
- Bolt
- 8 Nm
- Quantity: 2
- Side Adjusting Buffer
- Refer to Side Adjusting Buffer, Removing and Installing .
- Refer to Side Adjusting Buffer, Adjusting .
- Rear Lid Seal
- Refer to Rear Lid Seal, Removing and Installing .
- Plug
- Left and right
- Nut
- 20 Nm
- Quantity: 2
- Striker
- Refer to Striker, Removing and Installing .
- Refer to Striker, Adjusting .
- Roof Joint Rear Lid Seal
- Clip
- Quantity: 8
- Plug
- Left and right
Tightening Specifications and Sequence
| Step | Nut | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -3- | Tighten to 20 Nm +45° |
| 2. | -3- | Loosening |
| 3. | -3- | Tighten to 20 Nm +45° |