Lower Adjusting Buffer, Adjusting
The procedure shown is for the left side of the vehicle as an example.
-- Remove the striker. Refer to Striker, Removing and Installing .
-- Turn the adjusting bolt -1- in the direction of -arrow A-.
Tip
At the same time, the height of the adjusting buffer -2- changes in the direction of -arrow B-.
-- Close the rear lid, at the same time pay attention to the correct position of the stop -2- in the side panel -1-.
Conditions
- The rear lid may not be positioned too far inward or outward when closed.
-- Check the adjustment.
-- Install the striker. Refer to Striker, Removing and Installing .