Rear Wheel Housing Liner, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Wheel Housing Liner

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Check the expanding nuts -2- for damage and replace if necessary.

-- Insert the wheel housing liner -1- in the fender and adjust it the installed position.

-- Secure the bracket and wheel housing liner to the fender with the bolt.

-- Install and tighten the bolts -3-.

Tightening specification for the bolts -3- : 2 Nm

-- If there is no sill panel cover installed, then install and tighten the bolt -4-.

-- Install the sill panel cover, if equipped. Refer to Sill Panel Cover .