Left/Right Hid Headlamp Control Module -J343- / -J344-

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

The Left HID Headlamp control module -J343- /Right HID Headlamp Control Module -J344- is installed on the lower headlamp.

The Left HID Headlamp control module -J343- /Right HID Headlamp Control Module -J344- is not equipped with OBD.

NOTE:

The illustrations show a Left HID Headlamp control module -J343-.

Removal

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the headlamp, refer to HEADLAMP .

-- Remove the screws -arrows- from the Left HID Headlamp control module -J343- -2-.

Fig 1: Identifying Left HID Headlamp Control Module With Screws

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Left HID Headlamp control module -J343- -2- from the headlamp -1-.

-- Remove the connection for the Left HID Headlamp control module -J343-.

Installation

CAUTION:

Make sure the seal fits correctly when Installation of the left HID headlamp control module -J343-. Water getting in the headlamp will cause damage.

Install in reverse order of removal. Note the following:

-- Install the headlamp, refer to HEADLAMP .

-- Check headlamp for functions.

-- Perform basic setting of headlamps, refer to HEADLAMP, PERFORMING BASIC SETTING .

Tightening Specifications

Refer to HID/XENON HEADLAMPS OVERVIEW .