Checking the Spring Connections and Rivet Connections

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Make sure the rivet connections -arrows B- fit correctly on all pull-springs -arrows A-.

• Replace any clutch pressure plates that have loose rivet connections -arrows B-.

Only Check Position of Adjustment Mechanism with New Pressure Plates

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Both edges -A- of the adjusting ring must be located between both notches -arrows B-.
• If the adjusting ring takes on a different position with new pressure plates, pressure plate and clutch plate must not be installed.
• With used clutches, the adjusting ring may take on a position outside of the notches.

-- Use the :3067  when installing.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Engines Having a Crankshaft with a Smaller Diameter -arrow-, or Engines Having a Needle Bearing -arrow- in the Crankshaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Centering the Clutch Plate, Removing and Installing the Pressure Plate on Engines with a Crankshaft with a Smaller Diameter, or Engines with a Needle Bearing in the Crankshaft.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Continuation for All

When Installing, Tighten Bolts as Follows So Pressure Plate Does Not Distort (Causing Shuddering on Acceleration):

-- Install the pressure plate on the centering pins.

-- Install all bolts evenly, by hand, until the bolt heads touch the clutch pressure plate.

-- Tighten the bolt diagonally in small steps.

-- Install the transmission. Refer to TRANSMISSION, INSTALLING .