Clutch Slave Cylinder With Release Bearing, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Tighten the slave cylinder bolts in small increments only.
Otherwise, there is the danger that the tabs with the fastening holes could break off.
-- Check the O-ring -3- on the clutch slave cylinder for damage.
-- Push the bleeder -4- onto the clutch slave cylinder connection -1- until the clip -2- clicks into place.
-- To check, pull on the bleeder.
-- Install the transmission. Refer to TRANSMISSION, INSTALLING .
-- Bleed the clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .