Work procedure

-- Connect the scan tool.

-- Start the engine and let run at idle speed.

-- Select Mode 6: Check test the results of components that are not continuously monitored.

Select the desired Test-ID.

The current minimum and maximum values will be displayed on the scan tool screen.

The following table is a numerical list of all "Test-IDs" that may be selected.

Monitor-ID	Component or System
$01: Monitor-ID $01: Oxygen Sensor Monitor Bank 1 - Sensor 1	Oxygen Sensor Monitor Bank 1 - Sensor 1
$02: Monitor-ID $02: Oxygen Sensor Monitor Bank 1 - Sensor 2	Oxygen Sensor Monitor Bank 1 - Sensor 2
$21: Monitor-ID $21: Catalytic Converter Monitoring	Catalytic Converter Monitoring
$35: Monitor-ID $35: Camshaft Adjustment Bank 1	Camshaft Adjustment Bank 1
$3C: Monitor-ID $3C: Tank Venting System Leak Test (0.020" / 0.5 mm)	Tank Venting System Leak Test (0.020" / 0.5 mm)
$3D: Monitor-ID $3D: Tank Vent Valve Function Check	Tank Vent Valve Function Check
$41: Monitor-ID $41: O2 Sensor Heater Bank 1 - Sensor 1	O2 Sensor Heater Bank 1 - Sensor 1
$42: Monitor-ID $42: O2 Sensor Heater Bank 1 - Sensor 2	O2 Sensor Heater Bank 1 - Sensor 2
$71: Monitor-ID $71: Secondary Air System Bank 1	Secondary Air System Bank 1
$A2: Monitor-ID $A2: Misfire Cylinder 1 Data	Misfire Cylinder 1 Data
$A3: Monitor-ID $A3: Misfire Cylinder 2 Data	Misfire Cylinder 2 Data
$A4: Monitor-ID $A4: Misfire Cylinder 3 Data	Misfire Cylinder 3 Data
$A5: Monitor-ID $A5: Misfire Cylinder 4 Data	Misfire Cylinder 4 Data