Monitor-ID $35: Camshaft Adjustment Bank 1
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID $35".
-- Select the desired "Test-ID" or "Hex-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $80 | P0011 | VVT Intake Camshaft Diagnosis, Target Position Not Reached, Target Error. | 0.0° CRK | 10.0° CRK | Refer to DTC P0011 in the DTC summary table. Engine Control Module --, 2017 MY => P0011 |
| $81 | P000A | VVT Intake Camshaft Diagnosis, Specified Position Reached Too Slowly, Slow Response. | 10.0° CRK | 655.35° CRK | Refer to DTC P000A in the DTC summary table. Engine Control Module --, 2017 MY => P000A |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition OFF.