Monitor-ID $3C: Tank Venting System Leak Test (0.020" / 0.5 mm)
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID $3C".
-- Select the desired "Test-ID" or "Hex-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $83 | P0456 | NVLD Fine Leak Detection. | 10.0 | 65, 535.0 | Refer to DTC P0456 in the DTC summary table. Engine Control Module --, 2017 MY => P0456 |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition OFF.