Output Shaft, Disassembling And Assembling: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Press Plate :VW402
- Press Piece - Rod :VW407
- Press Piece - Multiple Use :VW412
- Press Piece - 60mm :VW415A
- Press Piece - Bushing - 50mm Diameter :VW432
- Press Piece - Press Tube :30-100
- -1- Puller - Kukko Internal - 28-37mm :Kukko 21/5
- -4- Puller - Kukko Counterstay :Kukko 22/1
- Inductive Heater :VAS6414
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure. See OVERVIEW - OUTPUT SHAFT