Shift Lever And Housing, Through 10.06: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Lubricate the bearing areas and the sliding surfaces.

Fig 1: Exploded View Of Shift Lever And Shift Housing (Through 10.06), Servicing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Lock Washer
- Removing and installing, refer to LOCK WASHER, REMOVING AND INSTALLING .
Bushing
Pressure Spring
Bushing
Bolt
- 5 Nm
Cover
Sound Insulation
Bearing Shell
Bearing Shell
Shift Lever Guide
Washer
Gasket
- Between the shift housing and the underbody.
- Self-adhesive.
- Affix to the shift housing.
Shift Lever
Shift Housing
Bushing
Pin
Bushing
Pressure Spring
- Installing, refer to PRESSURE SPRING, INSTALLING .
Selector Bracket
Bolt
- 5 Nm
Gasket
- Always replace.
Base Plate
- Bend the tabs in order to remove.
- Always replace.
Selector Cable
- To the selector bracket.
- Removing and installing, refer to SELECTOR CABLE AND SHIFT CABLE, REMOVING AND INSTALLING .
Shift Cable
- Removing from, and installing to the shift lever guide, refer to SELECTOR CABLE AND SHIFT CABLE, REMOVING AND INSTALLING .
Lock Washer
- Always replace.
Nut
- M8: 25 Nm
- M6: 8 Nm
- Quantity: 4
Bushing
- Fits in one position only
Lock Washer
- Always replace.