Timing Chain Covers Overview

1. O-ring 
   • Always replace.
   • Lubricate before installing.
2. Oil Dipstick Guide Tube 
3. Bolt 
   • 9 Nm
4. Bolt 
   • 9 Nm
5. Camshaft Adjustment Valve 1 -N205- 
   • Removing and installing, refer to Camshaft Adjustment Valve 1 -N205- .
6. Seal 
   • Replace if damaged.
   • Lubricate before installing.
7. Bolt 
   • Tightening sequence and specification; refer to Fig 2.
8. Upper Timing Chain Cover 
   • Removing and installing, refer to UPPER TIMING CHAIN COVER .
   • Tightening sequence, refer to Fig 2.
9. Gasket 
   • Replace if damaged.
10. O-ring 
    • Always replace.
    • Lubricate before installing.
11. Alignment Pins 
    • For centering the cover.
12. Lower Timing Chain Cover 
    • Removing and installing, refer to one of the following:
      • Jetta/GLI for MY 08 through 10, Jetta SportWagen (US)/Jetta Wagon (Canada) for MY 09. Refer to LOWER TIMING CHAIN COVER .
13. Bolt 
    • Always replace.
    • Tightening sequence and specification; refer to Fig 3.
14. Seal 
    • For the vibration damper.
    • Removing and installing, refer to VIBRATION DAMPER SEAL, REPLACING .
15. Plug 
    • Always replace.

Special Tools And Workshop Equipment Required 

• Torque Wrench V.A.G 1783
• Open End Spanner Iner T AF 10 V.A.G 1783/1

Procedure 

-- Tighten the bolts in 2 passes in sequence -1 through 5- as follows:

-- Tighten the bolts by hand.

-- Tighten the bolts to 9 Nm.

Special Tools And Workshop Equipment Required 

• Torque Wrench (5-50 Nm) V.A.G 1331

Procedure 

-- Tighten the bolts in 3 passes in sequence -1 through 15- as follows:

1. Tighten the bolts hand tight.

2. Tighten the bolts to 8 Nm.

3. Tighten the bolts an additional 45° (1/8) turn.