Leak Detection Pump

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the right rear wheel housing liner. Refer to FRONT WHEEL HOUSING LINER .

-- Disconnect the vacuum line -1-.

Fig 1: Disconnecting Leak Detection Pump (LDP) V144 Electrical Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the electrical connector -2-.

-- Disconnect the vent line -3- by pressing the release button.

-- Remove the nuts -arrows-.

-- Disengage the leak detection pump with bracket.

Installing

Install in reverse order of removal. Note the following:

The vent line -3- must engage audibly.

-- Install right rear wheel housing liner. Refer to FRONT WHEEL HOUSING LINER .

Tightening Specifications: Refer to EVAP SYSTEM COMPONENT OVERVIEW