LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2008 >> R32 >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Clutch - 5-Speed Manual Transmission 0A4 (As Of 06.2011)) >> 30 Clutch >> Description And Operation >> Clutch System Component Overviews >> Clutch Pedal

Clutch Pedal

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Pedal Assembly, Assembly Overview
GWWN30-10067Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Bulkhead
    • With the studs for the mounting bracket.
  2. Gasket
    • Always replace.
    • Between the mounting bracket and the bulkhead.
    • With self-adhesive.
    • Attached to the mounting bracket.
  3. Mounting Bracket
    • For clutch pedal mounting.
    • Some equipment versions have a sound absorber installed. Refer to Fig 2.
    • Removing and installing, refer to one of the following:

      Rabbit for Model Year (MY) 2006-2009, refer to MOUNTING BRACKET .

      Golf from MY 2010, refer to .

  4. Bolt
  5. Over-Center Spring
    • Removing and installing, refer to one of the following:

      Rabbit for MY 2006-2009, refer to OVER-CENTER SPRING .

      Golf from MY 2010, refer to .

  6. Bushing
  7. Pin
  8. Clutch Pedal
    • Removing and installing, refer to one of the following:

      Rabbit for MY 2006-2009, refer to CLUTCH PEDAL .

      Golf from MY 2010, refer to .

  9. Mount
    • To remove and install, detach the master cylinder from the clutch pedal. Refer to one of the following:

      Rabbit for MY 2006-2009, refer to CLUTCH PEDAL .

      Golf from MY 2010, refer to .

  10. Gasket
    • Always replace.
    • Between the master cylinder and the mounting bracket.
  11. Clutch Master Cylinder
    • Remove and install after removing the mounting bracket. Refer to MASTER CYLINDER .
  12. Clutch Position Sensor -G476-
    • Removing and installing, refer to Clutch Position Sensor -G476- .
    • Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester.
    • The clutch position sensor is called the clutch pedal switch -F36- in "Guided Fault Finding".
  13. Clip
    • The clip must be removed in order to remove/install the hose/line assembly.
  14. Supply Hose
    • Rubber
    • On the Rabbit from 12.05, the hose is made of plastic. Refer to Figure.
    • On the Golf from MY 2010, the hose is made of plastic. Refer to Figure.
  15. Self-Locking Nut
    • 25 Nm
    • Always replace.
    • Quantity: 3
    • For the mounting bracket to the bulkhead.
  16. Nut
    • 25 Nm
    • Always replace.
  17. Jounce Bumper
    • For the clutch pedal.
Fig 2: Bracket With Sound Absorber
GWWN30-10195Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
scientia non olet · About LEMON Manuals